The MC2 is a professional studio-quality stereo compressor in a compact half-rack format. Simple to use yet extremely powerful, the MC2 by Joemeek will bring out the best in any line-level stereo material and give the gloss of a professional studio to all your performances. It can be used for both recording/mastering, and live work.

Think of the MC2 as three separate pieces of equipment: •A line level stereo preamplifier
•A stereo Joemeek compressor
•A stereo width processor

Joemeek MC2 Stereo Compressor Specifications:

• Input impedances: Line: 20kohm
• Pre-amp overall gain: 6dB to 15dB
• Common mode rejection: 70dB
• Equivalent input noise: 95dBu (unweighted)
• Distortion: 0.001% (below Compressor threshold)
• Frequency response: 10Hz to 70kHz (-3dB)
• Maximum input before clipping: +19.5dBu
• Headroom before clipping: +19.5dBu
• Compressor threshold: 6dBu to +22dBu (variable)
• Compressor ratio: 1:1 to 10:1 (variable)
• Compressor attack time: 1 msec to 100 msec (adaptive)
• Compressor release time: 0.1 sec to 3 sec (adaptive)
• Nominal output levels: +4dBu/-10dBv
• Output impedance: 75ohm
• Output Level switch: 12dB attenuation
• Noise Floor: 95dBu (typical, with 0dB Input and Make Up gain)
• VU Meter: 8 segment bargraph
• Power supply:12V ac mains adaptor
• Power consumption: 12W
• Dimensions (W x H x D): 8.66" x 1.73" x 7.0", 220 x 44 x 180 mm
• Weight: 2.20 lbs., 1 kilo
• GR Hold Threshold: 10dBu to -50dBu (variable)
• Stereo Width Range: Mono/stereo/wide stereo (variable)
• GR Meter/VC Meter: 8 Segment bargraph

As Joe Meek always said, "If it sounds right, it is right." The MC2 will make your mixes sound right.